LPGWorks
Shell Catcher for Beretta A300 Ultima
Shell Catcher for Beretta A300 Ultima
SKU:LPGW-SHELL-BERET-A300-ULTIMA-12
The shell catchers were designed for use on the guns in their factory form. Any additional aftermarket parts such as charge handles or lifters that don't use factory dimensions may not be compatible.
These catchers clip on from the ejection port and clip over the loading port. To install, hook the top of the shell catcher over the ejection port. Line up the notch with the bolt release and snap the bottom part of the shell catcher over the loading port. The pin should be inside the recessed hole and keep the shell catcher from moving. This shell catcher indexes on the 1/16 roll pin on the side of the receiver. Make sure to align the pin over the roll pin. If the shell catcher does not sit flush, you will need to set the roll pin slightly lower until the shell catcher can sit flush with the receiver.
With all the feedback received, we have updated the design to address the following issues.
- Shell Catcher placement using the smaller roll pin recess
- The notch cut out was slightly shallow
Improvements made
- The smaller pin on the face of the receiver has been removed. The shell catcher now indexes using the roll pin hole that is located on the loading port side
- The notch cut out has been increased and lines up a little better
Please match up your receiver with the photo that is shown. If you are not sure, please contact us before placing your order.
Parts are 3D printed using PLA+.
6 in stock